Acoustics & Music Theory
why it sounds like that
Concept

Node — where it appears

A point on a vibrating object where a given mode has no motion, or in an air column no pressure variation. Where a string is struck or a hole is drilled relative to a mode's nodes decides whether that mode is excited or destroyed.

Named by 7 essays across 2 fields — each of them below, with the objects they name alongside it.

The first eight partials of a string. A string vibrating in one, two, three and more equal parts, with the frequency ratio and the nearest named note beside each. The seventh partial is a third of a semitone flat of anything on a keyboard, which is a fact about strings rather than about tuning.

A string does everything at once

A plucked string does not vibrate at one frequency. It vibrates at all the whole-number multiples of one frequency simultaneously, and nearly everything in music theory is downstream of that fact.

timbre · Harmonic series C4, in every place it can be played. A guitar neck with the 4 places C4 can be stopped, drawn at the fret spacing a 64.8-centimetre scale actually has. The stave writes one note and the tablature writes one of these; each notation says exactly what the other leaves out. The speaking lengths run from 61.2 down to 27.2 centimetres, so a hand plucking 12 centimetres from the bridge meets between 20 and 44 per cent of the string.

What a tablature keeps

Middle C can be stopped in four places on a guitar. The speaking lengths run from 61 to 27 centimetres, so a hand plucking twelve centimetres from the bridge meets between a fifth and nearly a half of the string, and the comb of missing partials is different at every one: the second partial is thirteen decibels stronger in the best position than in the worst. A stave writes one note for all four. A tablature writes four different things and cannot say which note any of them is.

instruments · Notation One key, nineteen notes, one right answer. A register hole disturbs a mode in proportion to the square of that mode's pressure at the hole, so the place that spoils the fundamental and leaves the third harmonic alone is the third harmonic's own pressure node — a third of the way down whatever length is sounding. The length changes with every fingering and the key does not move, so the two curves cross at one note. At A3 the key sits almost exactly on the node and the twelfth speaks cleanly; at A♭4 it is at 62 per cent of the tube and disturbs the third harmonic by 96 per cent of what an antinode would, which is the throat of the instrument and is exactly where players say the notes are worst.

The hole that spoils a note

A tone hole shortens the tube. A register hole does the opposite job: it is small enough to shorten nothing and is placed where it will wreck the fundamental's resonance and leave the third harmonic's alone, so the note jumps a twelfth instead of retuning. The place that does both is a pressure node of the harmonic being kept — a third of the way along whatever length is sounding — and the length changes with every fingering while the key does not. One key is at the right place for exactly one note, and the note it is worst for is in the throat of the instrument, which is where players say the instrument is worst.

instruments · Tone holes How near the node a hammer has to land. The level of partial 7, relative to the loudest partial of the same note, against how far the hammer is from that partial's node — for a contact 2.6 per cent of the speaking length wide, which is 16 mm on a 620 mm string. At the node exactly the partial is absent whatever the width, because a mode shape is odd about its own node and integrating an odd function symmetrically gives zero. Twenty decibels of suppression needs the hammer within 2.82 mm, and thirty needs 0.89 mm. The width itself barely matters in the musical range: its sinc reaches its first zero only at partial 77.

The hammer is not a point either

The comb of missing partials is computed throughout for a contact of no width, and a piano hammer is sixteen millimetres of felt on a string of six hundred. Integrating the mode shape across the felt turns out not to fill the null in: a mode is odd about its own node, so a symmetric contact centred on it gives an exact zero however wide it is. What destroys the null is being in the wrong place, and the tolerance is 2.8 millimetres for twenty decibels of suppression and 0.89 for thirty. The design decision found at the outset is a manufacturing tolerance.

instruments · Excitation point One vent on a cone, over the notes it has to serve. A cone's modes are a full harmonic series, so the mode a register vent has to keep is the octave rather than the twelfth, and its pressure node sits at half the sounding length measured from the virtual apex. The apex is a fixed point of the instrument and the bell end is not, so every fingering moves the ideal position and there is one hole. The upper line is how much the vent spoils the fundamental, which is what it is for; the lower is how much it damages the octave, which is the cost. Their ratio runs from 451.2 at F♯4 down to 1.9 at B♭3 — a factor of 235 across a single register. The vent is placed at 37 per cent of the longest sounding length, which is where the worst fingering is least badly served.

The vent a cone cannot place

A clarinet's register key has to spoil a fundamental and leave a twelfth. A saxophone's has to spoil a fundamental and leave an octave, whose pressure node sits at half the sounding length from the virtual apex — and the apex is a fixed point while the bell end is not. Over one register the ideal position moves by a factor of two, and one hole is right for one note.

instruments · Tone holes Where one arch can put a bar's second and third partials. The plane of the second and third partials, with the path a single arch traces through it as it is cut deeper, for 4 arch lengths from 50 to 100 per cent of the bar. Every path starts at the plain bar's 2.756 and 5.404 and runs up and to the right. The xylophone's target of 3 and 6 lies on them: reach the second partial and the third is there. The marimba's target of 4 and 10 lies above every one of them — the best any of these arches manages while holding the second partial at 4 is 9.176, which is 149 cents short. A marimba's third partial is not something one cut can place, and that is a statement about the shape of the cut rather than about the maker.

One cut cannot place two partials

An arch cut into a bar's underside is one knob, and a maker aims it at two targets. Swept across every arch length, the path it traces through the plane of the second and third partials passes through the xylophone's 3 and 6 — dead through it, within a tenth of a cent at the natural arch length — and under the marimba's 4 and 10 by between 149 and 326 cents. Hitting one target means missing the other, and that is why a marimba bar's underside is not a simple arch.

instruments · Struck bar What each strike point on a marimba bar excites. The amplitude each of the first 4 partials receives from a strike at each point along the bar, each partial drawn to its own maximum. On a string this comb is |sin nπx| and is periodic, so one strike point silences a whole family; on a bar it is the mode shape itself, whose zeroes are not at rational fractions, so no strike point silences a family. The exception is the middle: every antisymmetric mode is zero there by symmetry, so a centre strike drives partial 1 at 100 per cent of its maximum and partial 2 at nothing at all. The cord's hole at 0.2031 is the mirror case — the fundamental is the partial a strike there cannot reach.

The four ways a marimba loses what its arch placed

The centre of a bar is a node of every even mode by symmetry, so a stroke there gives the second partial exactly nothing and a mallet's width cannot recover it; five millimetres off centre returns 14 per cent. Add the yarn mallet's 3-millisecond contact, the tube's rigid lid and a decay four times faster than the fundamental's, and four independent mechanisms take the tuned partial 80 decibels below it. On a xylophone the same four come to 24.

instruments · Struck bar

Named alongside it

The objects these essays reach for when they reach for this one.

PartialExcitation pointInharmonicityStanding waveBoreBoundary conditionBrightnessInstrument designIntonationOverblowingRegisterResonance

All concepts